Cause analysis of unstable lifting of hydraulic lifting platform

熟悉液壓舉升平臺的人都應該知道，當液壓舉升器舉升不穩定時，從現場使用的角度來看，煙包經常打滑，舉升位置難以察覺，中間位置找不到，舉升有噪音、漏油等現象。

Anyone familiar with the hydraulic lifting platform should know that when the hydraulic lifting device is unstable, from the point of view of on-site use, the cigarette bag often slips, the lifting position is difficult to detect, the middle position can not be found, and the lifting has noise, oil leakage and other phenomena.

現場檢查主要是由于液壓快速升降，導致故障率增加，嚴重影響生產效率，升降不穩的原因很多，具體如下：

The on-site inspection is mainly due to the rapid rise and fall of hydraulic pressure, which increases the failure rate and seriously affects the production efficiency. There are many reasons for the unstable rise and fall, as follows:

針對液壓舉升平臺系統故障，運用速度理論分析液壓舉升不穩定的原因：

Aiming at the failure of hydraulic lifting platform system, the causes of hydraulic lifting instability are analyzed by using speed theory:

(1)提升液壓回路、油泵溢流閥、換向閥、換向閥(無節流)和增壓缸的組成。

(1) Composition of lifting hydraulic circuit, oil pump overflow valve, reversing valve, reversing valve (without throttling) and booster cylinder.

(2)做好提升回路的剛度研究，進入液壓系統的總流量，即單向總流量公式是通過的總流量;液壓油的形狀和粘度以及其他相關系數，

(2) Do a good job in the stiffness research of the lifting circuit, and the total flow into the hydraulic system, that is, the total flow through the one-way total flow formula; Shape and viscosity of hydraulic oil and other correlation coefficients,

根據分析，我們很容易得出以下結論：

Based on the analysis, we can easily draw the following conclusions:

當負載保持不變時，節流閥口入口越小，系統越高;相反，如果閥門的開啟面積較大，則較低。

When the load remains unchanged, the smaller the throttle inlet, the higher the system; On the contrary, if the opening area of the valve is large, it is low.

負荷保持不變時，低速下硬度好，負荷變化時，小時率剛好。

When the load remains unchanged, the hardness is good at low speed, and when the load changes, the hourly rate is just right.

(3)供油壓力加大，液壓缸功能面積大，可提高硬度。

(3) The oil supply pressure is increased, and the functional area of the hydraulic cylinder is large, which can improve the hardness.

綜上所述，很多設備故障都與液壓有關，液壓電梯故障的主要原因是液壓系統升級和調速回路設計不合理，小編認為這方面要引起相關公司的重視，不要等到事故發生才后悔，得不償失。

To sum up, many equipment failures are related to hydraulic pressure. The main reason for the failure of hydraulic elevator is the unreasonable design of hydraulic system upgrade and speed regulation circuit. Xiaobian believes that this aspect should be paid attention to by relevant companies. Don't wait for the accident to regret, and the gain is not worth the loss.

那么我們?nèi)绾问褂靡簤荷灯脚_呢?

So how do we use the hydraulic lifting platform?

1.啟動前，需仔細檢查液壓升降平臺各部件，檢查螺絲連接是否可靠，液壓管路部件是否有泄漏，電線連接點是否松動或損壞。

1. Before starting, carefully check the components of the hydraulic lifting platform, check whether the screw connection is reliable, whether the hydraulic pipeline components have leakage, and whether the wire connection points are loose or damaged.

2.提升液壓升降臺前，將四個角放在支點上，四條支撐腿牢牢固定在堅實的地面上，桌面調整為水平(只需目測)，然后檢查所有零件的正常位移后開始工作。

2. Before lifting the hydraulic lifting table, put the four corners on the fulcrum, firmly fix the four support legs on the solid ground, adjust the table to be horizontal (only visual inspection), and then check the normal displacement of all parts before starting to work.

3.進入平臺后，關閉護欄門，插入螺栓，系好繩，中間載荷(人站的座位)盡可能位于控制臺中間。

3. After entering the platform, close the guardrail door, insert the bolt, fasten the rope, and the middle load (the seat of the human station) shall be located in the middle of the console as far as possible.

4、作業時嚴禁液壓平臺超載，平臺人員在起落下降時不得移動。

4. During operation, it is strictly prohibited to overload the hydraulic platform, and the platform personnel shall not move when taking off and falling.

5、牽引液壓平臺時，收好支腿，將平臺降較低位置，嚴禁在高處移動平臺。

5. When towing the hydraulic platform, close the outrigger and lower the platform to a lower position. It is strictly prohibited to move the platform at a high place.

以上就是今天帶給大家的知識，剪叉式液壓升降平臺專注行業多年，為用戶不斷的提供有價值的內容，更多內容請繼續關注我們：

The above is the knowledge brought to you today. The scissor hydraulic lifting platform has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: